IBM 9080-M9S

Table 4. Cabling a Four Node Conguration (continued)
Cable Cable type and length From To
3X 1225 mm (4.01
ft)
ND3-P1-T18 ND1-P1-T24
5W 1005 mm (3.3
ft)
ND3-P1-T23 ND2-P1-T23
5X 1005 mm (3.3
ft)
ND3-P1-T24 ND2-P1-T24
3Y 1225 mm (4.01
ft)
ND3-P1-T25 ND1-P1-T31
3Z 1225 mm (4.01
ft)
ND3-P1-T26 ND1-P1-T32
5Y 880 mm (2.9
ft)
ND3-P1-T31 ND2-P1-T31
5Z 880 mm (2.9
ft)
ND3-P1-T32 ND2-P1-T32
Cables originating on ND2
6C 1005 mm (3.3
ft)
ND2-P1-T7 ND1-P1-T7
6D 1005 mm (3.3
ft)
ND2-P1-T8 ND1-P1-T8
6A 1225 mm (4.01
ft)
ND2-P1-T15 ND1-P1-T15
6B 1225 mm (4.01
ft)
ND2-P1-T16 ND1-P1-T16
6W 1225 mm (4.01
ft)
ND2-P1-T17 ND1-P1-T17
6X 1225 mm (4.01
ft)
ND2-P1-T18 ND1-P1-T18
6Y 1005 mm (3.3
ft)
ND2-P1-T25 ND1-P1-T25
6Z 1005 mm (3.3
ft)
ND2-P1-T26 ND1-P1-T26
4. Press the SMP cable and the blue tab together with your ngers and thumb to hold the SMP cable. Plug
the SMP cable into the previously identied location in the system node by inserting the cable into the
connector until it locks into place, as shown in the following gure.
Lightly pull on the SMP cable to ensure it is locked into place. The cable must be rmly attached to the
system.
Cables
37