CA00E1DC
Explanation: Dynamic console selection
Response:
1. Verify the video session and the SOL session. The console might be redirected to the video controller.
2. Start a remote control session or access the local KVM to see the status.
3. Go to Checkout procedure.
4. Replace the system-board, as described in Replacing the system-board and chassis assembly.
CA00E1DD
Explanation: A graphics adapter has been selected as the firmware console, but the USB keyboard is not attached.
Response:
1. Verify that there is a USB keyboard attached to a USB port that is assigned to the partition.
2. If the problem persists:
a. Go to Checkout procedure.
b. Replace the system-board, as described in Replacing the system-board and chassis assembly.
CA00E1F0
Explanation: Start out-of-box experience
Response:
1. Go to Checkout procedure.
2. Replace the system-board, as described in Replacing the system-board and chassis assembly.
CA00E1F1
Explanation: Start self test sequence on one or more devices
Response:
1. Go to Checkout procedure.
2. Replace the system-board, as described in Replacing the system-board and chassis assembly.
CA00E1F2
Explanation: Power on password prompt
Response:
1. Go to Checkout procedure.
2. Replace the system-board, as described in Replacing the system-board and chassis assembly.
CA00E1DC • CA00E1F2
280 Power Systems: IBM Flex System p260 and p460 Compute Nodes Installation and Service Guide
To Next Page
Loading...
