316 IBM Midrange System Storage Hardware Guide
Validate SNMP configuration
To validate the SNMP configuration, select the SNMP trap destination and click Test to send
a test trap to the RSM host (Figure 6-25).
Figure 6-25 Send test trap
Check the activity log (as shown in Figure 6-23 on page 314) and verify that the trap was
received. The activity log will contain a entry, as shown in Example 6-6.
Example 6-6 Test alert received
2009 09 04 22:05:08 UTC - Received a test alert for ITSO53000 from 9.11.218.181
6.2.5 Activating RSM
The final step is to activate your system. Complete all the other configurations and run a
successful Configuration Test before contacting IBM Service to activate RSM.
To Next Page
Loading...
Need help?
General