488 IBM Midrange System Storage Hardware Guide
Enclosure commands
Table 8-5 lists these commands.
Table 8-5 Enclosure commands
Array commands
Table 8-6 lists these commands.
Table 8-6 Array commands
Command Description
download enclosure
firmware
This command downloads ESM firmware.
set enclosure id This command sets the ID of a DS4800 82A/84A storage subsystem.
The range of valid IDs is from 80 through 99. This range avoids conflicts
with existing drive module IDs used for attached expansion enclosures.
set enclosure
serviceAllowedIndicator
This command turns on or turns off the Service Action Allowed indicator
light on the power-fan canister or interconnect module in a DS4800
82A/84A subsystem.
start enclosure locate This command locates an enclosure by turning on the indicator lights.
stop enclosure locate This command turns off the enclosure indicator lights that were turned
on by the start enclosure locate command.
Command Description
delete array This command deletes an entire array and its associated logical drives.
There can be potential storage subsystem configuration damage.
revive array This command forces the specified array and associated failed physical
disks to the Optimal state.
set array This command defines the properties for an array.
show array This command returns the following information about an array:
Status (online or offline)
Drive type (Fibre or SATA)
Enclosure loss protection (yes or no)
Current owner (controller slot A or slot B)
Associated logical drives and free capacity
Associated physical disks (drives)
start array
defragment
This command starts a defragment operation on the specified array.
To Next Page
Loading...
Need help?
General