IBM Midrange System DS4000 Series

476 IBM Midrange System Storage Hardware Guide
8.1.2 CLI parameters
Example 8-1 shows the help information that is displayed after executing SMcli -? in the
command prompt window of a WIN platform; a similar output will be seen from a UNIX
command line prompt.
Example 8-1 Help on SMcli
SMcli <DNS-network-name-or-IP-address>
[<DNS-network-name-or-IP-address>]
[-c "<command>;[<command2>;...]"]
[-n <storage-array-name> | -w <WWID>]
[-o <outputfile>] [-p <password>] [-e] [-S] [-quick]
SMcli <DNS-network-name-or-IP-address>
[<DNS-network-name-or-IP-address>]
[-f <scriptfile>]
[-n <storage-array-name> | -w <WWID>]
[-o <outputfile>] [-p <password>] [-e] [-S] [-quick]
SMcli {-n <storage-array-name> | -w <WWID>}
[-c "<command>;[<command2>;...]"]
[-o <outputfile>] [-p <password>] [-e] [-S] [-quick]
SMcli {-n <storage-array-name> | -w <WWID>}
[-f <scriptfile>]
[-o <outputfile>] [-p <password>] [-e] [-S] [-quick]
SMcli -d [-i] [-s] [-w] [-v] [-S]
SMcli -A [<DNS-network-name-or-IP-address1> [DNS-network-name-or-IP-address2]] [
-S]
SMcli -X (-n <storage-array-name> | -w <WWID> | -h <hostName>)
SMcli -m <ip address> -F <e-mail address> [-g <contactInfoFile>] [-S]
SMcli -x email:<e-mail address>
[<hostname or IP address1> [<hostname or IP address2>]]
[-n <storage-array-name> | -w WWID | -h <hostName>]
[-S]
SMcli -a email:<e-mail address>
[<hostname or IP address1> [<hostname or IP address2>]]
[-n <storage-array-name> | -w <WWID> | -h <hostName>]}
[-I <informationToInclude>] [-q <frequency>] [-S]
SMcli {-a | -x} trap:<community>,<hostname or IP address>
[<hostname or IP address1> [<hostname or IP address2>]]
[-n <storage-array-name> | -w <WWID> | -h <hostName>]
[-S]
SMcli -?
For additional information, refer to your Command Line Interface documentation
SMcli completed successfully.
Note: The method of accessing help on a CLI interface can vary depending on the
operating systems. Enter SMcli without any parameters to display a short help message.