IBM Midrange System DS4000 Series - Host Topology Commands

Chapter 8. Command-line interface and Script Editor 491
Host topology commands
Table 8-8 lists these commands.
Table 8-8 Host topology commands
FlashCopy commands
Table 8-9 lists these commands.
Table 8-9 FlashCopy commands
Command Description
create host This command creates a new host.
create hostGroup This command creates a new host group.
create hostPort This command creates a new host port.
delete host This command deletes a host.
delete hostGroup This command deletes a host group.
delete hostPort This command deletes a host port.
set host This command assigns a host to a host group or moves a host to a different
host group.
set hostGroup This command renames a host group.
set hostPort This command changes the host type for a host port.
show allHostPorts For all host ports connected to a storage subsystem, this command returns
the following information:
򐂰 Host port identifier
򐂰 Host port name
򐂰 Host type
Command Description
create
FlashCopyLogicalDrive
This command creates a FlashCopy logical drive.
recreate FlashCopy This command starts a fresh copy-on-write operation using an existing
FlashCopy logical drive.
set logicalDrive This command defines the properties for a FlashCopy logical drive
and enables you to rename a FlashCopy logical drive.
stop flashcopy This command stops a copy-on-write operation.