Chapter 7. Advanced maintenance, troubleshooting, and diagnostics 361
3. You are then presented with a warning, as shown in Figure 7-32. Make sure that you have
suspended all I/O to the adapter before you proceed.
Figure 7-32 Qlogic SANsurfer BIOS update
4. Acknowledge the warning and click Yes. You must use the BIOS update file.
5. Select the corresponding file for your adapter. In Figure 7-33, we show the download for a
Qlogic 234x adapter.
Figure 7-33 Qlogic SANsurfer HBA FC2-133 BIOS update file
Once you have selected the file, you will be prompted for the password. The default password
for all adapters is
config. Once the upload is finished, you will be prompted to reboot the
server so the changes can take effect. You can upload BIOS for multiple adapters
subsequently before rebooting the server. Remember, if you do not reboot the server, the
changes will not take effect.
To Next Page
Loading...
Need help?
General