IBM Midrange System DS4000 Series User Manual

420 IBM Midrange System Storage Hardware Guide
With controller firmware Version 07.60.xx, the host types shown in Table 7-2 are recognized.
Table 7-2 Host types
There are also scripts available to change the default ADT setting for specific host types. This
might be required for SAN boot to work correctly. See the relevant documentation for usage
instructions in IBM Midrange System Storage Implementation and Best Practices Guide,
SG24-6363.
Host type ADT status
AIX Disabled
AIX-ADT/AVT Enabled
DEFAULT Disabled
HP-UX Enabled
HPXTPGS Disabled
IBM TS SAN VCE Enabled
Irix Disabled
LNXCLVMWARE Disabled
Linux Enabled
Linux_DMP Disabled
NetWare Failover Enabled
Solaris (with Veritas DMP) Enabled
Solaris (with or without MPXIO) Disabled
Unused1 Enabled
Windows 2000/Server 2003/Server 2008
Clustered
Disabled
Windows 2000/Server 2003/Server 2008
Clustered (supports DMP)
Enabled
Windows 2000/Server 2003/Server 2008
Non-Clustered
Disabled
Windows 2000/Server 2003/Server 2008
Non-Clustered (supports DMP)
Enabled
Note: There are two host type definitions for Windows 2000/Server 2003/Server 2008
Clustered and Windows 2000/Server 2003/Server 2008 Clustered Non-Clustered. The
entries with the (supports DMP) suffix are only valid if VERITAS DMP is used as the
multipath driver.

IBM Midrange System DS4000 Series Specifications

General

Brand	IBM
Model	Midrange System DS4000 Series
Category	Storage
Language	English