IBM Midrange System DS4000 Series User Manual

484 IBM Midrange System Storage Hardware Guide
clear storageSubsystem
eventLog
This command clears the storage subsystem event log by deleting
the data in the event log buffer.
There is potential storage subsystem configuration damage.
clear storageSubsystem
firmwarePendingArea
This command deletes, from the pending area buffer, a firmware
image or NVSRAM values you have previously downloaded.
There is potential storage subsystem configuration damage.
disable storageSubsystem
featurePack
This command disables a storage subsystem premium feature.
download storageSubsystem
driveFirmware
This command downloads firmware images to all physical disks in
the storage subsystem.
download storageSubsystem
firmware
This command downloads firmware and, optionally, NVSRAM
values for the storage subsystem controller.
download storageSubsystem
NVSRAM
This command downloads NVSRAM values for the storage
subsystem controller.
enable storageSubsystem
featureKey
This command enables a feature using a feature key file.
reset storageSubsystem
batteryInstallDate
This command resets the age of the batteries in a storage
subsystem to zero days.
reset storageSubsystem
RLSBaseline
This command resets the Read Link Status (RLS) baseline for all
devices.
reset storageSubsystem
logicalDriveDistribution
This command reassigns (moves) all logical drives to their preferred
controller.
save storageSubsystem
configuration
This command creates a script file that you can use to create the
current storage subsystem logical drive configuration.
save storageSubsystem
allEvents
This command saves events from the Major Event Log (MEL) to a
file. You can save either all the events or only the critical events.
save storageSubsystem
performanceStats
This command saves the performance statistics to a file. Before you
use this command, issue the set session
performanceMonitorInterval and set session
performanceMonitorIterations commands to specify how often
statistics are collected.
save storageSubsystem
RLSCounts
This command saves the RLS counters to a file. Before using this
command, issue the reset storageSubsystem RLSBaseline
command to get current data.
save storageSubsystem
stateCapture
This command saves the state capture to a file.
Command Description

IBM Midrange System DS4000 Series Specifications

General

Brand	IBM
Model	Midrange System DS4000 Series
Category	Storage
Language	English