About this task
This task assumes that the following conditions were met:
v The expansion enclosure was moved out from the rack on the slide rails, as
described in “Removing an expansion enclosure from a rack: 2145-92F” on page
104
v The top cover was removed, as described in “Removing the top cover: 2145-92F”
on page 56.
v The display panel assembly was removed, as described in “Removing the
display panel assembly: 2145-92F” on page 130.
Procedure
1. Remove the display panel assembly, which is shown in Figure 127 on page 134,
from its packaging.
Chapter 4. Installing an optional 5U SAS expansion enclosure 133
To Next Page
Loading...
Need help?
General
