Home
IBM
Controller
MTM 2145-SV1
IBM MTM 2145-SV1
214 pages
Manual
To Next Page
To Next Page
To Previous Page
To Previous Page
Loading...
v
After
service,
reinstall
all
safety
shields,
guards,
labels,
and
ground
wires.
Replace
any
safety
device
that
is
worn
or
defective.
v
Reinstall
all
covers
correctly
after
you
have
finished
servicing
the
unit.
Safety
and
environmental
notices
xix
18
20
Table of Contents
Main Page
Default Chapter
3
Table of Contents
3
Figures
5
Tables
7
Safety and Environmental Notices
9
Safety Notices and Labels
9
Caution Notices for the SAN Volume Controller
10
Danger Notices for SAN Volume Controller
14
Special Caution and Safety Notices
18
General Safety
18
Inspecting the SAN Volume Controller System for Unsafe Conditions
22
Checking the Grounding of a SAN Volume Controller
24
Emergency Power-Off Shutdown
24
Handling Static-Sensitive Devices
24
Environmental Notices
25
About this Guide
27
Emphasis
27
Who Should Use this Guide
27
SAN Volume Controller Library and Related Publications
28
SAN Volume Controller Library
28
IBM Websites for Help, Services, and Information
28
IBM Publications Center
29
IBM Documentation and Related Websites
29
How to Get Information, Help, and Technical Assistance
30
IBM Websites for Help, Services, and Information
30
Related Websites
30
Sending Your Comments
30
SAN Volume Controller Initial Installation Overview
33
Chapter 1. Preparing to Install the SAN Volume Controller
35
Applicable Machine Types and Models
35
Machine Types and Models
35
SAN Volume Controller Operating Environment
36
Rack Cabinet Physical Location
36
SAN Volume Controller 2145-SV1 Front Panel Controls and Indicators
37
SAN Volume Controller 2145-SV1 Front Panel
37
SAN Volume Controller 2145-SV1 Operator-Information Panel
38
SAN Volume Controller 2145-SV1 Rear-Panel Indicators
40
Fibre Channel Leds
40
SAN Volume Controller 2145-SV1 Rear-Panel
40
SAS Port Leds
41
Link Status Values for Fibre Channel Leds
41
AC, DC, and Power-Supply Error Leds
42
SAS Port Leds
42
Identify Button and LED
43
SAN Volume Controller 2145-SV1 Ethernet Port Leds
43
SAN Volume Controller 2145-SV1 AC, DC, and
43
Ethernet Ports on the System Board
44
Ethernet Port Leds on the System Board
44
Ethernet Port
44
SAN Volume Controller 2145-SV1 Connectors
45
Ethernet Port Leds on a 10 Gbps Ethernet Adapter
45
Connectors on the Rear of the SAN Volume Controller 2145-SV1
45
SAN Volume Controller 2145-SV1 Ports Used During Service Procedures
46
SAN Volume Controller 2145-SV1 Unused Ports
46
Power Connector
46
SAN Volume Controller 2145-SV1 Service Ports
46
SAN Volume Controller 2145-SV1 Fibre Channel and Ethernet Port Numbers
47
SAN Volume Controller 2145-SV1 Unused
47
The Pcie Expansion Slots in Which an Adapter Can be Used
47
Fibre Channel Port Numbers in a Typical
48
Ethernet Port Numbers for Iscsi
48
Chapter 2. Installing the SAN Volume Controller 2145-SV1 Hardware
49
Preparing for the SAN Volume Controller 2145-SV1
49
Hardware Installation
49
Parts Provided for SAN Volume Controller 2145-SV1 Hardware Installation in a Rack
50
Installing the SAN Volume Controller 2145-SV1
52
Installation Guidelines
52
Installing the Support Rails: 2145-SV1
52
Detaching the Inner Rail Section
53
Attach Inner Rail Section to Chassis
54
Install the Bracket Assembly to the Frame
54
Installing the SAN Volume Controller 2145-SV1 in a Rack
55
Installing the Cable Management Arm Assembly for the SAN Volume Controller 2145-SV1
56
Insert the Chassis into the Rack
56
Parts for Installing the SAN Volume Controller
57
Reversing the Orientation of the Assembly
58
Install the Inner Member
58
Install the Outer Member
58
Connecting the SAN Volume Controller 2145-SV1 to the SAN and to the Ethernet Network
59
Install the Other Outer Member
59
Verifying the SAN Volume Controller 2145-SV1 Installation
60
Ethernet Ports on the Rear of the SAN Volume Controller 2145-SV1
60
Fibre Channel Ports
60
SAN Volume Controller 2145-SV1 Front Panel
61
Chapter 3. Installing an Optional 2U SAS Expansion Enclosure
63
Installing Support Rails for 2U SAS Expansion Enclosures
63
Expansion Enclosure Support Rails
63
Installing the Rail Spring
64
Hole Locations in the Front of the Rack
65
Opening the Hinge Brackets
66
Closing the Hinge Brackets
66
Installing the Optional 2U SAS Expansion Enclosure into the Rack
67
Removing Enclosure End Caps
67
Connecting the Optional 2U SAS Expansion Enclosures to the 2145-SV1
68
Inserting the Enclosure into the Rack
68
SAS Cable Connector Orientation
69
Connecting the SAS Cables
70
Combining 2U and 5U Expansion Enclosures
71
Examples of Supported SAS Chain
71
Chapter 4. Installing an Optional 5U SAS Expansion Enclosure
73
Safety Notices and Considerations: 2145-92F
73
Weight Considerations: 2145-92F
79
Weight of Expansion Enclosure Parts
80
Weight of Expansion Enclosure SAS Drives
81
Identify the Hardware Components: 2145-92F
84
Features on the Front of the 2145-92F
84
Front Fascia of the 2145-92F Expansion
85
Features on the Rear of the 2145-92F Expansion
85
Unpacking and Installing the Enclosure: 2145-92F
87
Tray Containing Expansion Enclosure Parts
88
Packaging Materials
89
Removing the Top Cover: 2145-92F
90
Packaging for Fascia
90
Releasing the 2145-92F Cover
91
Removing the 2145-92F Cover
91
Enclosure
91
Installing or Replacing the Support Rails: 2145-92F
92
Detaching the Inner Rail Section
93
Screw Locations to Attach the Inner Rail to the
93
Attaching the Inner Rail Section to the
94
Installing the Rail Assembly to the Rack Frame
94
Installing or Replacing an Expansion Enclosure in a Rack: 2145-92F
95
Example of Required Rack Space
95
Example Installation of the Enclosure in the
101
Replacing the 2145-92F Enclosure in the Rack
102
Installing or Replacing an Expansion Canister: 2145-92F
103
Removing or Moving the Cable-Management Arm: 2145-92F
104
Install the Expansion Canister
104
Upper and Lower Cable-Management Arms
105
Connectors for the Upper Cable Management
106
Moving the Cable Management Arms
107
Components of the Lower CMA Assembly
107
Upper and Lower CMA Assemblies Moved
108
Lower CMA Assembly Moved
108
Installing or Replacing the Cable-Management Arm: 2145-92F
109
Release the Upper CMA Assembly
109
Release the Lower CMA Assembly
109
Upper and Lower Cable-Management Arms
110
Connectors for the Cable Management Arm
111
Install the Inner Connector of the Upper CMA
111
Install the Inner Connector of the Upper CMA
112
Attach the Support Rail Connector of the Upper
112
Comparing the Location of the Components of
113
Installing or Replacing the Top Cover: 2145-92F
114
Aligning the 2145-92F Top Cover
114
Installing or Replacing a Drive: 2145-92F
115
Replacing the 2145-92F Top Cover
115
Locking the Top Cover
115
Drive Assembly
116
Drive Locations in a 2145-92F Expansion
117
Correct Drive Installation
117
Incorrect Drive Installation
118
Installing or Replacing a Secondary Expander Module: 2145-92F
120
Location of Secondary Expander Modules
121
Leds on a Secondary Expansion Module
122
Installing or Replacing the Fascia: 2145-92F
123
Replace the Secondary Expander Module
123
Fascia Components on the Expansion Enclosure
124
Installing or Replacing a Power Supply: 2145-92F
125
Replace Fascia Components on the Expansion
125
Preparing to Install the Power Supply
126
Install the Power Supply
127
Removing the Fascia: 2145-92F
128
Power Supply Indicators
128
Fascia Components on the Expansion Enclosure
129
Remove Fascia Components from the Expansion
130
Removing and Installing a SAS Cable: 2145-92F
131
Fascia Removed from the Psus
131
Correct Orientation for SAS Cable Connectors
132
Example of SAS Cables Routed through the Cable Management Arms
133
Installing or Replacing a Fan Module: 2145-92F
134
Installing or Replacing a Fan Interface Board: 2145-92F
135
Fan Module Orientation
135
Replace Fan Module
135
FIB Parts for the Chassis
136
Insert the New FIB in the Chassis
137
Secure the FIB to the Drive Board
137
Removing an Expansion Enclosure from a Rack: 2145-92F
138
Replace the FIB Cover
138
Removing the 2145-92F Enclosure from the Rack
145
Removing a Power Supply: 2145-92F
146
Releasing the Power Supply Handles
147
Removing a Drive: 2145-92F
148
Removed Power Supply
148
Drive Assembly
149
Drive Locations in a 2145-92F Expansion Enclosure
150
Removing a Secondary Expander Module: 2145-92F
151
Replace the Drive
151
Remove the Drive Assembly
151
Location of Secondary Expander Modules
153
Location of Leds on the Secondary Expander
153
Remove the Secondary Expander Module
154
Secondary Expander Module Connectors
155
Secondary Expander Module Removed from the Enclosure
155
Removing an Expansion Canister: 2145-92F
156
Removing a Fan Module: 2145-92F
157
Removing the Expansion Canister
157
Fan Module LED
158
Fan Module Release Tab
158
Removing a Fan Interface Board: 2145-92F
159
Remove Fan Module
159
Fan Module LED
160
Location of the FIB Cover
160
Loosen the FIB Screws
161
Remove the FIB from the Chassis
161
Replacing an Enclosure: 2145-92F
162
FIB Parts Removed from the Chassis
162
Removing the Display Panel Assembly: 2145-92F
164
Removing the Display Panel Assembly
165
Installing or Replacing the Display Panel Assembly: 2145-92F
166
Display Panel Assembly
166
Display Panel Assembly
168
Removing the Support Rails: 2145-92F
169
Installing the Display Panel Assembly
169
Remove the Rail Assembly from the Front Frame Bracket
169
Connecting the Optional 2145-92F SAS Expansion Enclosures
170
Remove the Rail Assembly from the Rear Frame
170
SAS Cable Connector Orientation
170
Connecting the SAS Cables
172
Combining 2U and 5U Expansion Enclosures
173
Examples of Supported SAS Chain
173
Powering on the Expansion Enclosure: 2145-92F
174
Features on the Front of the 2145-92F
175
Power Cable Connections on the Back of the
176
Powering off the Expansion Enclosure: 2145-92F
177
Expansion Canister
177
Features on the Rear of the 2145-92F
177
SAN Volume Controller 2145-92F Expansion Enclosure Leds and Indicators
178
Leds on the Front of the Expansion Enclosure
179
Display Panel Leds
179
Leds on the Front of a Power Supply Unit
180
Power Supply Unit Leds
180
Leds on a Drive Assembly
181
LED Indicators on Drives
181
Leds on a Secondary Expansion Module
182
LED Indicators on Secondary Expansion
182
Leds on the Back of the Expansion Enclosure
183
Leds on the Back of the Expansion Canister
183
Expansion Canister and SAS Port Leds
184
Chapter 5. Initializing the SAN Volume Controller 2145-SV1 System
185
Checking Your Web Browser Settings for the Initialization GUI
185
User Name and Password for System Initialization
187
Default User Name and Password for the Initialization GUI
187
Initializing the SAN Volume Controller 2145-SV1 System by Using the Technician Port
188
Technician Port
188
Adding Nodes to an Existing System
189
Node Model Names and Software Version Requirements
189
Appendix A. Accessibility Features for SAN Volume Controller
193
Appendix B. Where to Find the Statement of Limited Warranty
195
Appendix C. SAN Volume Controller Physical Installation Planning
197
SAN Volume Controller 2145-SV1 Environment Requirements
197
Power Consumption
197
Physical Specifications
197
Additional Space Requirements
198
Maximum Heat Output of each SAN Volume Controller 2145-SV1 Node
199
Notices
201
Trademarks
203
Homologation Statement
203
Electronic Emission Notices
203
Federal Communications Commission (FCC) Statement
203
Industry Canada Compliance Statement
204
Australia and New Zealand Class a Statement
204
European Union Electromagnetic Compatibility Directive
204
Germany Electromagnetic Compatibility Directive
204
People's Republic of China Class a Statement
205
Taiwan Class a Compliance Statement
206
Taiwan Contact Information
206
Japan Voluntary Control Council for Interference Class a Statement
206
Japan Electronics and Information Technology Industries Association Statement
206
Korean Electromagnetic Interference (EMI) Statement
207
Russia Electromagnetic Interference Class a Statement
207
Index
209
Related product manuals
IBM ServeRAID M5210
37 pages
IBM ServeRAID M5014
106 pages
IBM ServeRAID M5015
106 pages
IBM ServeRAID M5110e
17 pages
IBM ServeRAID M1215 SAS
35 pages
IBM ServeRAID M1015 SAS/SATA
4 pages
IBM ServeRAID
29 pages
IBM FlashSystem 5000
19 pages
IBM ServeRAID-8 Series
58 pages
IBM 3174
43 pages
IBM ServeRAID-8i
58 pages
IBM ServeRAID-8k
58 pages
To Next Page
Loading...
