MAP 1700 (continued)
Refer to “Software Installation Procedure” on page 4-48 and install
the correct software on the hard disk.
046
(From steps 042 and 044)
– Repeat the operation or diagnostic test that failed.
DID THE SYMPTOM REMAIN?
Yes No
047
You have successfully completed the Advanced Diagnostics tests. If
you suspect an intermittent problem, start an error log. If you need
instructions, refer to “Error Log” on page 3-9.
Note: The hard disk can now be prepared to accept data. The
Advanced Diagnostics Format program is different from the
operating system format program. Before the customer can
transfer information from the backup diskettes, the hard disk
must be formatted using the operating system diskette.
048
Replace the system board.
Note: The hard disk can now be prepared to accept data. The Advanced
Diagnostics Format program is different from the operating system
format program. Before the customer can transfer information from
the backup diskettes, the hard disk must be formatted using the
operating system diskette.
049
(From step 020)
IS THE PROBLEM THAT THE REMOTE LED FOR THE HARD DISK
DRIVE DOES NOT LIGHT?
Yes No
050
(Step 050 continues)
2-88