MAP 1700 (continued)
054 (continued)
IS THERE A SECOND HARD DISK DRIVE INSTALLED?
Yes No
055
Go to Step 062 on page 2-91.
056
WERE YOU ABLE TO RUN THE ADVANCED DIAGNOSTIC TESTS ON
BOTH OF THE HARD DISK DRIVES?
Yes No
057
– Power off the system unit.
– Disconnect the power cable from the second hard disk drive.
– Power on the system unit.
– Check the voltages at the hard disk drive end of the power cable.
– Pin 1 to frame ground +12 V dc.
– Pin 4 to frame ground +5 V dc.
4
1
Hard Disk Power Cable
(Step 057 continues)
2-90
To Next Page
Loading...
