IBM PS/1 User Manual

MAP 0010 (continued)
Figure 2-1. POST Errors
066
(From steps 015, 040, and 064)
(Step 066 continues)
POST Error Action
No beep and:
Blank or unreadable display
Blinking cursor
Machine functioning properly
1XX error
MAP 0020: Power
MAP 0020: Power
MAP 0020: Power
MAP 0100: System Board
One long and one short beep MAP 0200: Memory
One long and two short beeps MAP 2400: Video Graphics Array
One long and three short beeps MAP 2400: Video Graphics Array
Two short beeps and:
Blank or unreadable display
Distorted display image
30X error
6XX error
11XX error
17XX error
24XX error
2408 error
2410 error
86XX error
XXXXXX XXXX 201 error
111, 129 error
162 without a device error
2XX error
MAP 2400: Video Graphics Array
MAP 2400: Video Graphics Array
MAP 0300: Keyboard
MAP 0600: Diskette Drive
MAP 1100: System Board Serial Port
MAP 1700: Hard Disk Drive
MAP 2400: Video Graphics Array
Replace the system board.
Replace the system board.
MAP 8600: Mouse
MAP 0200: Memory
MAP 0200: Memory
Check the Configuration Utility for any
flagged option(s) and add or delete
the missing device(s). Refer to “Using
the Configuration Utility” on
page 1-14. If you cannot add or
delete a device, go to the MAP for
that device and test.
MAP 0200: Memory
Continuous beep MAP 0020: Power
Repeating short beeps MAP 0020: Power
Any other errors Go to Step 071 on page 2-18.
2-16

IBM PS/1 Specifications

General

Processor	Intel 80286 or 80386
Processor Speed	10 MHz (80286)
RAM	1 MB (expandable to 2 MB or more)
Storage	40 MB hard drive
Floppy Drive	3.5" 1.44 MB
Graphics	VGA
Ports	Serial, Parallel, Mouse