MAP 0010 (continued)
067 (continued)
– Power on the system unit.
Note: If you know of a failure that has occurred because of an adapter
card, answer the following question “Yes.”
DO YOU HAVE ANY ERROR CODES OR FAILURE SYMPTOMS?
Yes No
068
Go to Step 070.
069
Go to “MAP 2000: Riser Card” on page 2-93.
070
(From step 068)
The Advanced Diagnostics tests finished without detecting a failure.
If you are still experiencing a failure:
– Check all adapter jumper positions.
– Check all adapter switch settings.
– Check all cables and connectors for proper installation.
– Run the Advanced Diagnostics tests on all devices. Use the RUN TESTS
ONE TIME option. If you receive an error, go to the MAP indicated by the
error code. For example, if you receive the error code 6XX, go to “MAP
0600: 3.5-Inch Diskette Drive” on page 2-58.
If you are experiencing a problem with a device not supported by this
manual, refer to that device’s service manual for special testing
instructions.
If you suspect an intermittent problem, start an error log. If you need
instructions, refer to “Error Log” on page 3-9.
071
(From steps 059, 065, and 066)
(Step 071 continues)
2-18
To Next Page
Loading...
Need help?
General
