IBM PS/1 User Manual

MAP 0100 (continued)
Figure 2-4. POST Errors
010
(From step 009)
This error indicates a problem with the nonvolatile memory.
– Make a note of any error messages and press Esc.
DID THE ERROR MESSAGE GO AWAY WHEN ESC WAS PRESSED?
Yes No
011
Go to “MAP 0300: Keyboard” on page 2-54.
012
DID THE ADVANCED DIAGNOSTICS MENU APPEAR?
Yes No
013
Go to “MAP 0600: 3.5-Inch Diskette Drive” on page 2-58.
014
– Press 3 (SETUP), then press Enter. When the Configuration Utility
screen appears, press Esc.
– Power off the system unit and wait 10 seconds.
– Power on the system unit.
(Step 014 continues)
Error Code Action
161 Go to Step 010 on page 2-32.
163 Go to Step 019 on page 2-33.
162, 164 Go to MAP 0010 step 001 on page 2-4.
101, 107 Go to “MAP 0020: Power” on page 2-20.
1XX (not listed) Replace the system board.
129 Go to “MAP 0200: Memory” on page 2-36.
2-32

IBM PS/1 Specifications

General

Processor	Intel 80286 or 80386
Processor Speed	10 MHz (80286)
RAM	1 MB (expandable to 2 MB or more)
Storage	40 MB hard drive
Floppy Drive	3.5" 1.44 MB
Graphics	VGA
Ports	Serial, Parallel, Mouse