IBM PS/1 User Manual

028
(From step 008)
DID YOU RECEIVE A 104 ERROR?
Yes No
029
Replace the system board.
Note: After replacing the system board, run the Configuration Utility
by selecting 3 (SETUP) and set the date and time to remove
any 16X errors.
030
Replace the battery.
Note: After replacing the battery, run the Configuration Utility by selecting 3
(SETUP) and set the date and time to remove any 16X errors.
Diagnostic Information 2-35

IBM PS/1 Specifications

General

Processor	Intel 80286 or 80386
Processor Speed	10 MHz (80286)
RAM	1 MB (expandable to 2 MB or more)
Storage	40 MB hard drive
Floppy Drive	3.5" 1.44 MB
Graphics	VGA
Ports	Serial, Parallel, Mouse