MAP 0200 (continued)
067 (continued)
– Press 0 (SYSTEM CHECKOUT), then press Enter.
– Press Y when the Installed Devices menu appears.
– Use the RUN TESTS ONE TIME option.
– Follow the screen instructions to run the Memory tests.
DID YOU RECEIVE AN ERROR?
Yes No
068
IS YOUR SYSTEM BOARD A 486SX OR A 486DX (WITH 30-PIN
MEMORY SIMMS)?
Yes No
069
Your system memory is now functioning correctly. If you
suspect an intermittent problem, start an error log. If you need
instructions, refer to “Error Log” on page 3-9.
070
DID YOUR SYSTEM BOARD CONTAIN EIGHT SIMMS?
Yes No
071
Your system memory is now functioning correctly. If you
suspect an intermittent problem, start an error log. If you need
instructions, refer to “Error Log” on page 3-9.
072
– Power off the system unit.
– Remove the four SIMMs installed in bank 0 and install the four
SIMMs you removed at the beginning of this map in bank 0.
– Power on the system unit.
(Step 072 continues)
2-48
To Next Page
Loading...
