System event/error log messages
A system event/error log is generated only if a Remote Supervisor Adapter II
SlimLine is installed. The system event/error log can contain messages of three
types:
Information Information messages do not require action; they record significant
system-level events, such as when the server is started.
Warning Warning messages do not require immediate action; they indicate
possible problems, such as when the recommended maximum
ambient temperature is exceeded.
Error Error messages might require action; they indicate system errors,
such as when a fan is not detected.
Each message contains date and time information, and it indicates the source of
the message (POST/BIOS or the service processor).
Note: The BMC system event log, which you can view through the
Configuration/Setup Utility program, also contains many information, warning, and
error messages.
In the following example, the system event/error log message indicates that the
server was turned on at the recorded time.
- - - - - - - - - - - - - - - - - - - - -
Date/Time: 2002/05/07 15:52:03
DMI Type:
Source: SERVPROC
Error Code: System Complex Powered Up
Error Code:
Error Data:
Error Data:
- - - - - - - - - - - - - - - - - - - - -
The following table describes the possible system event/error log messages and
suggested actions to correct the detected problems.
68 IBM System x3650 Type 7979 and 1914: Problem Determination and Service Guide
To Next Page
Loading...
