Instructions for IBM Business Partners
Instructions for IBM Business Partners on verifying the newly installed devices by
running the Dynamic System Analysis (DSA) stress test.
In addition to the instructions in this chapter for installing optional hardware
devices, updating firmware and device drivers, and completing the installation,
IBM Business Partners must also complete the following steps:
1. Before you configure a server for a customer, complete the Solution Assurance
checklist at http://www.ibm.com/support/assure/assur30i.nsf/webindex/
sa294/.
2. After you have confirmed that the server starts correctly and recognizes the
newly installed devices and that no error LEDs are lit, run the Dynamic System
Analysis (DSA) stress tests. For information about using DSA, see the Problem
Determination and Service Guide.
3. Shut down and restart the server multiple times to ensure that the server is
correctly configured and functions correctly with the newly installed devices.
4. Save the DSA log as a file and send it to IBM.
5. To ship the server, repackage it in the original undamaged packing material
and observe IBM procedures for shipping.
Support information for IBM Business Partners is available at http://
www.ibm.com/partnerworld/.
Server components
The following illustrations show the major components in the server.
Note: The illustrations in this document might differ slightly from your hardware.
26 System x3650 M3 Types 4255, 7945, and 7949: Installation and User’s Guide
To Next Page
Loading...
Need help?
General