2
Contents
INTRODUCTION
Principle of Operation
Flow Monitoring
Alarms
1 SYSTEM CONTROLS
1.1 The E-Series Display Panel
User Functions
2 INSTALLATION
2.1 Mounting Diagrams
2.2 Connection of Cables
2.2.1 FT1, 4, 6, 8, 15 Connections
2.2.2 PICO Connections
2.2.3 Standby Battery (optional)
2.2.4 Operation of the FireTracer e-series from 24 Volts DC only
2.3 Connection of Sampling Tubes
2.4 Power-Up
2.5 Flow normalisation (Wide bore systems Pico, FT1, 4, 6)
2.6 Connecting the e-series Display Panel remotely
2.7 Configuring the e-series to drive a remote display panel
3 SETUP AND BUTTON FUNCTIONALITY
3.1 User Functions (No Access Code required)
3.2 Main Menu & Access Code Entry
3.3 Operator Functions (Operator Code or above required)
3.4 Main Menu
3.4.1 Engineering (No Code Required)
Engineering Values
3.4.2 Configure
3.4.3 Set Sector Day/Night Alarms
3.4.4 Set Time and Date
3.4.5 Set IP Address and IP Mask
3.4.6 Set-up Menu
3.5 I/O Modules
3.5.1 4 Channel Relay Module
3.5.2 8 Channel 4-20mA Output Module
3.5.3 12 Channel Analogue Input Module
3.5.4 2 Extinguisher Module
4 INSTALLATION GUIDE FOR RS 485 EQUIPMENT
4.1 Electrical Supply
4.2 Cable Material
4.2.1 Common Mode
4.2.2 Interference Induced on to Cable
4.2.3 Terminating Cables
5 E-SERIES WEB SERVER
6 E-SERIES MONITOR SOFTWARE
6.1 PC Connection
6.2 Software Installation
6.3 Software Set-up
6.4 Using the Software
6.4.1. E-series display panel emulator
6.4.2. E-series Configuration Utility
6.4.3. Engineering and Maintenance
6.4.4. Data Logger
6.4.5 Logging Extraction Application
6.4.6 Flow Diagnostic Log
7 MAINTENANCE
3
3
3
4
5
5
5
7
7
9
9
11
15
15
15
16
16
17
17
18
18
18
19
21
21
21
22
25
26
26
27
28
28
29
30
32
33
33
33
33
34
34
35
37
37
37
37
38
38
39
40
41
42
42
43
To Next Page
Loading...