4 Press [Green] key to enter the following
menu.
Scan Mode.
1 There is two modes. You can scan channels
“By Channel” or “By Frequency”.
2 When scan band is UHF and region is
“France”, the range of Ch No. is from 21 to
69. When scan band is VHF and region is
“France”, the range of Ch No. is from 1 to 9.
(It’s according to region)
3 Press [Red] key to enter blind scan menu, or
press [Green] key to enter TP scan menu.
4 Press [Exit] key to exit the scan.
10.5 Cable Installation
Press [OK] key to enter the selected item.
You can select the Scan Mode, Manual
Scan or Blind Scan.
You can input the Frequency by using
the numeric buttons of the RCU.
If you set the Scan Mode to Blind Scan
you can input the Second Frequency
by using the numeric buttons of the
RCU.
You can input the Symbol Rate by use
the numeric button of the RCU.
You can select the QAM value from
16QAM, 32QAM, 64QAM, 128QAM
and 256QAM.
If you set the Scan Mode to Manual
Scan you can turn ON or OFF the NIT
Search.
When you complete your changes,
press OK button on Search to enter
Scan menu and then press OK button
to begin scan.
11. Preference
When you enter the “Preference” menu, you will
see a screen like below:
In “Preference” menu:
Press [Channel Up/Channel Down] key to
select menu item: Language, Parental
Lock, Control Time setting, Timer, A/V
To Next Page
Loading...
