8. Basic Operations
8.1 Turn on STB
First, press the [Device’s Main Power] to turn on
the unit. When the STB is first used it will show
the Main Menu. If channels are already installed
the, STB will play the same channel as last time
before turning off.
Frequently Asked Questions
Q: The power of my STB has been turned on
and not in Standby mode, but the TV
screen showed nothing:
A: Make sure the TV set has been set to the
correct video input (not the TV channels). For
example, if you have connected the unit with the
Video1 input of the TV set, the TV set has to be
switched to Video1.
Q: The power of my STB has been turned on
(not in Standby mode), but the TV screen
showed nothing except one box with “No
Signal” image.
A: This means there is no signal for the channel
which you have selected. It could be several
causes:
1 The channel which you selected is not on
your allocated satellite. The simple solution
is to change channel.
2 The signal of current TV channel is too
weak. You can try to change channel to a
stronger signal channel. If the problems still
exist, please consult your local dealer or
other professionals for technical service.
3 You are using a different LNB, and you
need to Modify LNB Type
8.2 Power
1 Press [Power] Key can enter the Standby
state.
2 In Standby state, press [Power] Key again
to wake the unit and go on to view the last
channel.
3 User can also disconnect the device’s main
power to end the Standby state.
8.3 Channel Up/Channel Down
In full screen, press [CH+/CH-] to change
channel.
8.4 Volume Up/Volume Down-
In full screen, press [VOL+/VOL-] to adjust
volume.
8.5 Number
In full screen, use number key and press [OK]
on the Remote Control Unit to change channel.
8.6 Mute
1 Press [MUTE] key to mute the sound and
the screen will show up mute OSD.
2 Press [MUTE] key again to restore sound.
8.7 Pause
1 In play mode, press [Pause] key, the
picture will be paused, but the sound of the
channel will still continues.
2 Press [PLAY] key again, the screen’s
picture will skip over to the live picture, and
the sound of the channel will correspond to
the live image.
8.8 Recall
Press [RETURN] key to directly switch to the
previous channel that you viewed before current
channel.
To Next Page
Loading...