Icom i9100

105
8
DV MODE OPERATION
■ Calling a specific station (Continued)
D Conrming the setting
q In the DR mode, p ush [MENU] one or more times to
display the “D1” screen.
w P ush [CS](F-1) to display the “CS” screen (Call
Sign).
e P ush [Z](F-1) one or more times to sequentially
displaythe“UR,”“R1,”“R2”or“MY”toconrmthe
current call sign setting.
NOTE: In the DR mode, you can change only the
“MY”callsigninthe“CS” screen (Call Sign).
[CS]/[Z][MENU]
CS UR
JG3YMK
JA3YUA
MY
R1
JP3YHL
R2 JP3YHJ
Ú
MY call sign：
JA3YUA
Station call sign：
JG3YMK
Repeater q ： NARA43 (JP3YHL)
Repeater r ： IKOMA43 (JP3YHJ)
GRP3
D1
R1:NARA43
CS CD R>CS UR DSET
D Settings for “UR” and “R2,” depending on the communication form
Destination: CQ Destination: An individual station
<Communication form: Local area call>
CQ
•URsetting:CQCQCQ
•R2setting:N/A
<Communication form: Local area call>
•URsetting:Anindividualstation
•R2setting:NOTUSE✱
<Communication form: Zone call>
CQ
•URsetting:DestinationrepeatertosendCQin
the same zone
•R2setting:N/A
<Communication form: Zone call>
•URsetting:Anindividualstation
•R2setting:Destination repeater in the same
zone
<Communication form: Gateway call>
CQ
•URsetting:DestinationrepeatertosendCQ
•R2setting:N/A
<Communication form: Gateway call>
•URsetting:Anindividualstation
•R2setting:GW
NOTE: R1 setting is set to your access repeater’s call sign.