Icom i9100

169
14
SET MODE
D The Tone control Set mode settings
q Push [MENU] one or more times to display the “M2”
screen (Menu 2).
w Push [TCON](F-4) to enter the Tone control Set
mode.
e Push a mode switch to select the desired operating
mode.
r Push [Y](F-1) or [Z](F-2) to select the desired
item.
 •Selectableitemsdiffer,dependingontheselectedoper-
ating mode.
t Rotate [MAIN DIAL] to select the desired option.
 •Youcanselecttheoptionforeachoperatingmode.
 •Holddown[F-3]for1secondtoresettothedefaultset-
ting, if desired.
y Push [MENU] to save, and exit the Set mode.
Select the item
Reset to the default
setting
Mode switches
[∫]
[MENU]
[F-3] [TCON]
[MAIN DIAL]
[√][√]
Ù 1 Ú
SSB
[ – – – ] – – – –
TCON
RX HPF⁄LPF
Displays the Set mode
item name and number
Displays the option
RX HPF/LPF 1. (Default: OFF)
(Mode: SSB/CW/RTTY/AM/FM/DV)
First select the operating mode, then set the receive
audio high-pass filter to between 100 Hz and 2000 Hz
in 100 Hz steps.
RX HPF/LPF 2. (Default: OFF)
(Mode: SSB/CW/RTTY/AM/FM/DV)
First select the operating mode, then set the receive
audio low-pass filter to between 500 Hz and 2400 Hz
in 100 Hz steps.
RX Bass 3. (Default: 0)
(Mode: SSB/AM/FM/DV)
First select the operating mode, then set the receive
audio bass level to between –5 and +5.
RX Treble 4. (Default: 0)
(Mode: SSB/AM/FM/DV)
First select the operating mode, then set the receive
audio treble level to between –5 and +5.
TX Bass 5. (Default: 0)
(Mode: SSB/AM/FM/DV)
First select the operating mode, then set the transmit
audio bass level to between –5 and +5.
TX Treble 6. (Default: 0)
(Mode: SSB/AM/FM/DV)
First select the operating mode, then set the transmit
audio treble level to between –5 and +5.
TBW(WIDE) L 7. (Default: 100)
(Mode: SSB)
Set the lower cut-off frequency of the transmission
passband width for your wide setting to 100, 200, 300
or 500 Hz.
TBW(WIDE) H 8. (Default: 2900)
(Mode: SSB)
Set the higher cut-off frequency of the transmission
passband width for your wide setting to 2500, 2700,
2800 or 2900 Hz.
Displays the selected
operating mode
■ Tone control Set mode description
NOTE:
•Whenthereceiveaudiohigh-passorlow-passlterisactive,“RXBass”and“RXTreble”itemswillberesetto
the default value.
•Whenthereceiveaudiobassorreceiveaudiotreblelevelisset,“RXHPF/LPF”items(1and2)willbeturned
OFF.