Icom i9100

168
14
SET MODE
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
USB2/DATA1 Func 64. (Default: -----/[GPS ])
Select the function of the [DATA1] jack.
•----- : The [DATA1] jack is not used.
•RTTY :UsedtosendRTTYdecodedsignals.
•DVdat :Usedforlow-speeddatainputandoutput.
•GPS :UsedfortheGPSreceiverconnectionfor
position data input.
GPS Out 65. (Default: OFF)
When a GPS receiver is connected to the [DATA1]
jack, the GPS position data is input through the jack.
Youcanselectwhetherornottosendthedatafrom
the COM port (“USB2”).
NOTE:Youcanusethisfunctiononlywhen“-----”
or “DVdat” is selected as the “USB2/DATA1 Func”
(63) option, and “GPS” is selected as the “USB2/
DATA1 Func” (64) option.
•OFF  :TurnsthefunctionOFF.
•DATA1➔ USB2 : Sends the GPS position data from
the COM port (“USB2”).
DVdat/GPS Out Baud 66. (Default: 4800)
Set the DV or GPS data transfer speed to 4800 or
9600 bps.
RTTY Decode Baud 67. (Default: 9600)
SettheRTTYdecodemonitorspeed to300,1200,
4800, 9600 or 19200 bps.
Calibration Marker 68. (Default: OFF)
Use as a simple frequency check of the transceiver.
See page 179 for calibration procedure.
NOTE: Turn OFF the calibration marker after check-
ing the frequency of the transceiver.
•OFF:CalibrationmarkerOFF
•ON :CalibrationmarkerON
REF Adjust 69.
During frequency calibration, set the internal refer-
encefrequencytobetween0%and100%rangein1%
steps.
NOTE: The default setting is different for each
transceiver.