■ Message operation
D TX message programming
The transceiver has a total of 5 message memories
to store short messages to transmit during DV mode
operation. Message of up to 20 characters can be pro-
grammed for each memory.
q
In the DV mode, p
ush [MENU] one or more times to
display the “M3” screen (Menu 3).
•IntheDRmode,p
ush [MENU] once or twice to select
the “D1” screen.
w
P
ush [DSET](F-5) to display the “DSET” screen.
e
P
ush [TXM](F-3) to display the “TXM” screen
(Transmit message).
r Rotate [MAIN DIAL] to select the desired transmit
message channel.
•TM1toTM5andOFFareselectable.
t Push [EDT](F-1) to enter the transmit message pro-
gramming mode.
•Acursorappearsandblinks.
y Push [F-1] one or more times to select the desired
character type.
Character type Selectable characters
ABC A to Z
abc a to z
etc
!#$%&\?" ’ ` ^ + – ✱⁄.,:;=
< > ( ) [ ] { } ¦ _ ¯ @
u Rotate [MAIN DIAL] to select the first character to
input.
When inputting numbers or a decimal point, push
the appropriate keypad key.
•Push[DEL](F-4)todeletetheselectedcharacter,sym-
bol or number.
•Push[SPC](F-5)toinputaspace.
•When all 20 characters havebeen programmed, an
error beep sounds. If you want to reprogram, push [Ω]
(F-2) or [≈](F-3) to select a character, then push [DEL]
(F-4) to delete it.
i Push [Ω](F-2) to move the cursor backward, or push
[≈](F-3) to move the cursor forward.
o Repeat steps y through i to program a message
of up to 20 characters.
!0 Push [MENU] to save the programmed message.
While [SET](F-5) is blinking, push it to set the dis-
played channel as the first appearance channel
when [TXM](F-3) is pushed in step e.
ABC
TXM
≈
TM1：HELLO
Ω≈
DEL SPC
[MAIN DIAL]
[MENU] [TXM]
[DSET][EDT]
Rotate [MAIN DIAL]
ABC
TXM
≈
TM1：HELLO
Ω≈
DEL SPC
Character type display Cursor
[Ω][≈]
[DEL][SPC]
[MAIN DIAL]
Number input
Character type
selection
• Programing a transmit message
Input a space
Delete a character
Move cursor forwards
Move cursor backwards
Character type selection
To Next Page
Loading...
