Icom IC-7400 - I Programming a Memory; I Memory Clearing

62
7
MEMORY OPERATION
■ Programming a memory
Memory channel programming can be preformed ei-
ther in VFO mode or in memory mode.
DD
Programming in VFO mode
q Set the desired frequency and operating mode in
VFO mode.
w Rotate [M-CH] to select the desired memory chan-
nel.
•“BLANK” appears if the selected memory channel is a
blank channel (and does not have contents).
e Push [MW] for 1 sec. to program the displayed fre-
quency and operating mode into the memory chan-
nel.
•3 beeps are emitted when memory programming is suc-
cessful.
DD
Programming in VFO mode
q Select the desired memory channel with [M-CH] in
memory mode.
• Memory channel contents appear in the display.
•“BLANK” appears and no frequency readout is displayed
if the selected memory channel is a blank channel (and
does not have contents).
w Set the desired frequency and operating mode in
memory mode.
•To program a blank channel, use direct frequency entry
with the keypad or memo pads, etc.
e Push [MW] for 1 sec. to program the displayed fre-
quency and operating mode into the memory chan-
nel.
•3 beeps are emitted when memory programming is suc-
cessful.
■ Memory clearing
Any unnecessary memory channels can be cleared.
The cleared memory channels become blank chan-
nels.
q Select memory mode with [V/M].
w Select the desired memory channel with [M-CH].
e Push [M-CL] for 1 sec. to clear the contents.
•The programmed frequency and operating mode disap-
pear.
•3 beeps are emitted when memory clearing is success-
ful.
r To clear other memory channels, repeat steps w
and e.
[V/M] [M-CH]
[MW]
AGC DUP CMP TBW SCP
• [EXAMPLE]: Programming 7.088 MHz/LSB
into memory channel 12.
AGC DUP CMP TBW SCP
• [EXAMPLE]: Programming 21.280 MHz/USB
into memory channel 18.
[V/M] [M-CH]
[M-CL]
IC-7400.qxd 02.4.2 11:35 Page 62