Icom IC-7400 - I Programmed Scan;Fine Programmed Scan

70
8
SCANS
2001 NEW
■ Programmed scan/Fine programmed scan (VFO mode)
Programmed scan searches for signals between scan
edge memory channels P1 and P2. The default fre-
quencies for these memories are 0.500000 MHz and
29.99999 MHz, respectively. See p. 65 for scan edges
programming.
q Push [V/M] to select VFO mode, if necessary.
w Select the desired operating mode.
•The operating mode can also be changed while scan-
ning.
e Push [TS] to select a tuning step.
• The tuning step can also be changed while scanning.
r Push [MENU] to select M2.
t Push [F1 SCN] to select the scan menu.
• See p. 68 for scan condition.
•If the [RF/SQL] control function is set as “AUTO,” the
squelch is always open in SSB, CW and RTTY modes.
y Push [F1 PRO] to start the programmed scan.
• The MHz and kHz decimal points blink while scanning.
u When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume, VSC
setting and the squelch condition.
i To cancel the scan, push [F1 PRO].
•Rotating the tuning dial during scan also cancels scan
operation.
If the same frequencies are programmed into the
scan edge memory channel P1 and P2, pro-
grammed scan does not start.
DD
About the Fine programmed scan
During programmed scan, when a signal is received,
scan continues, but the tuning step is temporarily set to
10 Hz.
q Follow steps q to y above to start programmed
scan.
w During programmed scan, push [F3 FIN] to switch
between programmed scan and fine programmed
scan operation.
e Push [F1 PRO] to cancel the scan.
•Rotating the tuning dial during scan also cancels scan
operation.
[TS]
Tuning dial
[MENU]
[V/M]
Mode keys
F 1
F 2F 3 F 4 F 5
F 1
F 2 F 3 F 4 F 5
F 1
F 2F 3 F 4 F 5
SCN MEM SWR TCN VSC
PRO
∂
F FIN SPN SET
∂
F:±1Ok
PRO
∂
F FIN SPN SET
PROG
SCAN
Push [F1]
Push [F1] to start/cancel the scanning.
Push [F1]
F 1
F 2F 3 F 4 F 5
F 1
F 2F 3 F 4 F 5
PRO
∂
F FIN SPN SET
PROG
SCAN
PRO
∂
F FIN SPN SET
F-PROG
SCAN
Push [F3] to switch
between programmed
scan and fine pro-
grammed scan.
IC-7400.qxd 02.4.2 11:35 Page 70