Icom IC-M411 - Call Channel Programming; Channel Comments

8
3
BASIC OPERATION
New2001
n Call channel programming
You can program the call channel with your most often-used
channels in each channel group for quick recall.
q Push both [Y] and [Z] on the transceiver one or more
times to select the desired channel group (INT, USA, ATIS
or DSC) to be programmed.
w Push and hold [16•C] for 1 sec. to select the call channel
of the selected channel group.
• “CALL” and call channel number appear.
e Push and hold [16•C] again
for 3 sec. (until a long beep
changes to 2 short beeps)
to enter the call channel
programming condition.
• Channel number starts blink-
ing.
r Push [Y] or [Z] to select
the desired channel.
t Push [16•C] to program the
displayed channel as the
call channel.
• Push [CLR] to cancel.
• The channel number stops blinking.
n Channel comments
Memory channels can be labeled with alphanumeric com-
ments of up to 10 characters each for easy channel recogni
-
tion.
Comment is indicated at the channel comment indicator for
about 10 sec. after the channel selection, and the comment,
more than 7 characters long, automatically scrolls.
Capital letters, small letters (except f, j, k, p, s, v, x, z), 0 to 9,
some symbols (= M + – . /) and space can be used.
q Select the desired channel.
• Cancel Dualwatch, Tri-watch or Scan in advance.
w While pushing [CH•DUAL], push [16•C] to edit the chan-
nel comment.
• A cursor and the first charac-
ter start blinking alternately.
e Select the desired charac-
ter by pushing
[Y] or [Z].
• Push [CH•DUAL] or [16•C]
to move the cursor forward or
backward, respectively.
r Repeat step e to input all characters.
t Push [ENT] to input and set the comment.
• Push [CLR] to cancel and exit the condition.
• The cursor and the character stop blinking.
y Repeat steps q to t to program other channel com-
ments, if desired.