39
7
SET MODE
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
n Set mode programming
Set mode is used to change the conditions of the trans-
ceiver’s functions: Scan type, Scan resume timer, Dual/Tri-
watch, Operation beep, LCD backlight, LCD contrast, AF
level adjustment and Favorite channel.
Available functions may differ depending on dealer set-
ting.
q
Turn power OFF.
w While pushing [16•C], turn power ON to enter Set mode.
• “SCAN” appears at the channel comment indicator.
e After the display appears, release [16•C].
r Push [16•C] to select the desired item, if necessary.
t
Push [Y] or [Z] to select the desired condition of the
item.
y Turn power OFF, then ON again to exit Set mode.
D SET MODE CONSTRUCTION
• Dual/Tri-watch
• Scan resume
timer
• Operation beep
• AF level
adjustment
• LCD Contrast
• LCD Backlight
• Favorite channel • Scan type
, turn power ON.• To enter Set mode: While pushing
• To exit Set mode: Turn power OFF, then ON again.
• To select the item: Push . ( )
And pushing selects the condition./
Starting item
Scrolls
Scrolls
Scrolls
To Next Page
Loading...
