Icom IC-M411 - DSC Operation; MMSI Code Programming; MMSI Code Check

13
6
DSC OPERATION
5
6
n MMSI code programming
The 9-digit MMSI (Maritime Mobile Service Identity: DSC
self ID) code can be programmed at power ON.
This code programming can be performed only once.
After the code programming, it can be changed only
by your dealer or distributor.
q While pushing [MENU], turn power ON to enter MMSI
code programming condition.
• Turn power OFF in advance.
w After the display appears, release [MENU].
e Push [MENU] to enter the DSC menu.
r Push [Y] or [Z] to select “MMSI” and push [ENT].
• A cursor starts blinking.
t Input the specified MMSI code by pushing [Y] or [Z].
• Push [CH•DUAL] or [16•C] to move the cursor forward or back-
ward, respectively.
y After inputting the 9-digit MMSI code, push [ENT].
• “CONFIRMATION” scrolls at the channel comment indicator.
Scrolls
u Push [ENT], then input the same MMSI code as step t
for the confirmation.
i
Push [ENT] to set the code.
• Returns to the normal operation.
• Push [CLR] to cancel and exit the condition.
• If the different code is input, “INCORRECT” appears. Push
[ENT] and try steps t to u again.
D MMSI code check
The 9-digit MMSI (DSC self ID) code can be checked.
➥
Push [MENU] for 1 sec. to display the 9-digit MMSI (DSC
self ID) code.
• The MMSI code is displayed and scrolls at the channel com-
ment indicator.
• When no MMSI code is programmed, “NO MMSI” appears and
warning alarm sounds.
Scrolls