New2001
PROBLEM
POSSIBLE CAUSE
SOLUTION
REF.
No sound from speaker.
• Squelch level is too high.
• Volume level is too low.
• Speaker has been exposed to water.
p. 7
p. 7
p. 9
• Set [SQL] to the threshold point.
• Set [VOL] to a suitable level.
• Drain water from the speaker.
The transceiver does
not turn ON.
• Bad connection to the power supply.
p. 42• Check the connection to the transceiver.
Transmitting is impos
-
sible, or high power can
not be selected.
• Some channels are for low power or re
-
ceive only.
• The output power is set to low.
pgs. 5,
6, 50
p. 7
• Change channels.
• Push
[HI/LO] on the microphone to select
high power.
Scan does not start. • TAG channel is not programmed. • Set the desired channels as TAG channels. p. 11
No beeps. • Beep tones are turned OFF. • Turn the beep tone ON in Set mode. p. 40
Distress call cannot be
transmitted.
• MMSI (DSC self ID) code is not pro
-
grammed.
• Program the MMSI (DSC self ID) code.
p. 13
46
New2001
TROUBLESHOOTING
9
To Next Page
Loading...
