Icom IC-M411 - Transmitting a Group Call

24
6
DSC OPERATION
New2001
D Transmitting a Group call
The Group call function allows you to transmit a DSC signal
to a specific group only.
q Push [MENU] to enter the DSC menu.
w Push [Y] or [Z] to select “GROUP,” push [ENT].
e Push [Y] or [Z] to select the desired pre-programmed
Group address, push [ENT].
• The ID code must be set in advance. (p. 15)
r Push [Y] or [Z] to select the desired intership channel,
push [ENT].
• Intership channels are already preset into the transceiver in
recommending order.
• After pushing [ENT], Channel 70 is automatically selected and
“READY” appears at the channel comment indicator.
Push
t Push [ENT] to transmit the Group call.
• If Channel 70 is busy, the transceiver stands by until the chan-
nel becomes clear.
• Routine category only is available.
Transmitting
y After the Group call has been transmitted, the specified
channel (in step
r) is automatically selected.
Scrolls
After transmitting ‘ABLE’ ACK
u Push and hold [PTT] to communicate your message to
the responding ship.