Model 252
Label Printer/Applicator
Operators/Technical Manual
5.9 Blast Dwell _________________________________________________ 49
5.10 Label Feed Delay ___________________________________________ 49
5.11 Apply Delay ___________________________________________ 50
5.12 Smart Delay Smart Tamp _____________________________________ 52
5.13 Tamp Home Sensor Setup ________________________________________ 52
5.14 Setting up Tamp Applications _____________________________________ 53
5.14.1 Setting the Tamp Position ______________________________________ 53
5.14.2 Setting the Pressures __________________________________________ 55
5.14.3 Setting the Tamp Motion ______________________________________ 57
5.14.4 Adjusting the Air Assist _______________________________________ 59
5.14.5 Setting the Vacuum ___________________________________________ 59
5.15 Swing Tamp Setup ______________________________________________ 60
5.16 Dual Panel Tamp Setup __________________________________________ 60
5.17 Corner Wrap Setup ______________________________________________ 62
5.17.1 Label Dispense Adjustments____________________________________ 62
5.17.2 Label Application Adjustments _________________________________ 65
5.18 Low Label Detection Verification __________________________________ 67
6 Save/Recall _______________________________________________________ 68
6.1 Save Configuration ___________________________________________ 68
6.2 Recall Configuration __________________________________________ 69
6.3 System Configuration Information ___________________________________ 70
7 Dual Panel Application ______________________________________________ 71
7.1 Dual Panel Mode _____________________________________________ 71
7.1.1 Mode 1 _____________________________________________________ 71
7.1.2 Mode 2 _____________________________________________________ 71
7.1.3 Mode 3 _____________________________________________________ 71
7.1.4 Mode 4 _____________________________________________________ 71
7.1.5 Mode 5 _____________________________________________________ 72
7.2 Dual Panel Tamp Dwell ______________________________________ 72
7.3 Dual Panel Smart Delay ______________________________________ 72
IV. CARE, MAINTENANCE AND TROUBLESHOOTING _____________________ 0
1. Maintenance Schedule _______________________________________________ 1
2. General Cleaning and Inspection _______________________________________ 2
3. Bearings __________________________________________________________ 2
4. Troubleshooting ____________________________________________________ 3
To Next Page
Loading...
