ID Technology 252 - Page 8

Model 252
Label Printer/Applicator
Operators/Technical Manual
5. Main Voltage Selection_______________________________________________ 4
6. Motor Direction Selection_____________________________________________ 4
7. Changing the Fuses __________________________________________________ 5
8. Electronics Assembly ________________________________________________ 6
9. 252 Firmware Update ________________________________________________ 7
10. Printer/Applicator Interface Cable Pin Mapping _________________________ 12
11. Unwind Brake and Dancer Arm ______________________________________ 13
12. Rewind Assembly Maintenance ______________________________________ 15
12.1 Drive Belt Removal _____________________________________________ 15
12.2 Drive Belt Replacement __________________________________________ 16
12.3 Drive Pulley Replacement ________________________________________ 16
12.4 Drive Motor Replacement _________________________________________ 17
V. DRAWINGS AND DIAGRAMS ________________________________________ 0
Figure 1: 252 with Standard Tamp Dimensions ______________________________ 1
Figure 2: 252 with Heavy Duty Tamp Dimensions ____________________________ 2
Figure 3: 252N Basic Dimensions _________________________________________ 3
Figure 4: 252E Basic Dimensions _________________________________________ 4
Figure 5: 252E/U-Arm Basic dimensions ___________________________________ 7
Figure 6: 252E/Pedestal Base Basic Dimensions _____________________________ 9
Figure 7: 252 Wiring Diagram ___________________________________________ 11
Figure 8: Interface Board Layout _________________________________________ 12
Figure 9: External Connectors ___________________________________________ 13
Figure 10: Internal Connectors __________________________________________ 15
Figure 11: Exploded View, 252 Base Module ID100002/ID100003 _____________ 17
Figure 12: Exploded View, 252 Faceplate Assembly ID100033/ID100034 ________ 18
Figure 13: Exploded View, 252 Unwind Assembly ID100013/ID100014 _________ 20
Figure 14: Exploded View, 252 Rewind Assembly ID100021/ID100022 _________ 22
Figure 15: Assembly View, ID100001 Electronics Assembly __________________ 24
Figure 16: Exploded View, 252 Pneumatics Module ID100037/ID100038 ________ 25
Figure 17: Exploded View, 62200-XX Tamp Assembly_______________________ 26
Figure 18: Exploded View, 62260-XX Heavy Duty Tamp Assembly ____________ 27
Figure 19: Exploded View, 62190-XX Service Tamp Assembly ________________ 28
Figure 20: Exploded View, 62201-XX Swing Tamp Assembly _________________ 29
Figure 21: Exploded View, ID100240-12-XX Dual Panel Tamp Assembly NU/ND _ 30
Figure 22: Exploded View, ID100241-12-XX Dual Panel Tamp Assembly Reels Up 32
Figure 23: Exploded View, 62870-XX Corner Wrap Assembly _________________ 34
Figure 24: Exploded View, 252N Assembly ID100060/ID100065_______________ 37
Figure 25: Exploded View, 252E Assembly ID100070 _______________________ 38
Figure 26: Installation Instructions, 62130 Main Air Cutoff Assembly ___________ 40
Figure 27: Installation Instructions, 62150 Water Separator Assembly ___________ 41
Figure 28: Risk Assessment _____________________________________________ 42