Idexx VetTest User Manual

I–2
IDEXX VetTest* Chemistry Analyzer Operator’s Manual
Analyzer does not respond to command.
If using the VetTest keypad:
Cause: The key was not pressed firmly enough, or too quickly.
Solution: Press firmly on each keystroke until you hear a “beep.”
Cause: Screen instructions were not followed properly.
Solution: Follow screen instructions and carry out all instructions in sequence.
Cause: Keypad cable has become disconnected or the board has failed.
Solution: Call IDEXX Technical Support for assistance.
If using an external keyboard:
Cause: Not using a compatible keyboard.
Solution: 6TFBO95DPNQBUJCMFLFZCPBSEGPS)8BO"5DPNQBUJCMFGPS)8
Cause: External keyboard switches improperly set.
Solution: Refer to the keyboard’s instructions for proper switch setting.
Cause: “Num Lock” indicator not lit.
Solution: Press “Num Lock” key to activate.
Cause: The connection between the keyboard and the VetTest analyzer is faulty.
Solution: Turn off the VetTest analyzer, remove and reinsert the cable connection on the
back of the analyzer, and then turn on the VetTest analyzer.
Analyzer returns to Startup during analysis.
Cause: Temporary interruption of electrical supply.
Solution: Check electrical connections and supply.
Warning alarm sounds continuously.
Cause: Slide insertion tray is in the wrong position.
Solution: Pull back the slide tray completely into the rest position.
Warning alarm sounds as slide insertion tray is pushed in.
Cause: The VetTest analyzer is not yet ready to accept slides.
Solution: Check that all screen instructions have been carried out. The screen
display gives instructions for when slides can be inserted.

Idexx VetTest Specifications

General

Brand	Idexx
Model	VetTest
Category	Measuring Instruments
Language	English