68 iDirect Satellite Router Installation and Commissioning Guide
iDX Release 3.3
Software Package and Options Push
4. Contact the Network Operator, and request a Multicast Package Download of the remote
software package and a UDP options file push.
5. The Network Operator should perform the follow
ing steps in iBuilder:
a. Verify the remote-side configuration.
b. Select
Pa
ckage DownloadMulticast at the Network level of the iBuilder Tree.
c. Select the appropriate R
emote package under Hardware in the Multicast Download
dialog box.
d. Select only this remote in the Remotes secti
on of the Multicast Download dialog box.
e. Ensure that Reset is
not selected.
f. Click Start.
g. Wait for the software package download to complete.
h. Click Close to close the
Multicast Download dialog box.
i. Right-click
the remote in the iBuilder Tree and select Apply ConfigurationPush
Remote Side with Reset (UDP).
6. The Satellite Router restarts and the new software package and op
tions file become
active.
7. Obtain the new admi
n password from the Network Operator.
8. Log in to Web iSite with the new password.
9. Check the parameters in “V
erify the Download” on page69 to verify that the download
was successful.
10. If this is an Evolution X7 Satellite Router:
a. Have the Network Operator perform Step b through Step h
a second time to load the
second flash partition with the current software package.
b. Wait until the Network Operator indicates that the package download is complete.
c. In Web iSite, click the Admin button at the top of the W
eb page.
d. Refresh the browser Web page.
e. In the Software Loaded sec
tion of the AdminFile Management page, verify that
both Version 1 and Version 2 have the latest software release and build number in
the Version field. See Figure 35 on page 55.
Note: iDirect recommends loading the X7 software
package to the second
partition. This allows the Satellite Router to switch to the second partition
in the unlikely event of an unrecoverable error in the operational partition.