49
Stability Mode: Set the control method for printer operation stability. When set to
“Safe”, it slows down the speed however increases stability over “default”.
Color Sensor Calib: Set whether to use color panel recognition as the calibration
value of the sensor. .
“Disable” is set to the default value.
“Enable” is set to the Open Color Sensor Calibration value.
Open Color Sensor Calibration: Measure the value of the color sensor.
Cancel Only: Set to “USE”, only “Cancel” is displayed on the LCD display when and
error occurs.
Display CardEmpty: Set to “Display”, LCD shows Card Empty when no card on the
input hopper.
Front Device: When using SMART-70 Multi Hopper.
To Next Page
Loading...
