MAINTENANCE
• Change the Fuel
Filter
Element
,,--------
--------...,.
* Hot oil and components can cause personal injury.
* Fuel leaked or
spilled
on to hot surfaces can cause a
fire.
1.
Stop the engine
2.
Turn the fuel stop lever
CD
to the "closed"(OFF) position.
Loosen the ring nut
(l).
3.
Remove the cup ® and the element
@.
4.
Drain water and sediment into a suitable container.
NOTE: Always dispose
of
drained fluids as established by local
regulations.
5.
Clean the inside surface
of
the cup.
6.
Install the new element
®.
7.
Install cup ®. Tighten ring nut (l).
8.
Turn the fuel stop lever
CD
to the "opened" (ON) position.
NOTE: Do not start the engine until all fuel system service
is
completed.
9.
There should be enough fuel
in
the system to allow the
engine to start. Keep the engine start switch key at ON for a
period
of
20 seconds. which operates the fuel pump and
priming automatically.
•
Check
the Travel Drives Oil Level
;--------
----------
When the quantity
of
oil is found to have increased
abnormally, it is necessary to check the oil seal
of
the travel
motor.
If the seal is leaking, contact a IHI dealer.
1.
Position one travel drive with oil drain plug
CD
at the bottom.
2.
Remove the oil level/fill plug (l) Oil should be to the bottom
of
the level plug opening.
3.
Add oil through the opening
of
oil level/fill plug • if
necessary.
4.
Clean the plugs (l). Install the plugs (l).
5.
Perform procedure on the other travel drive.
4-8-3
17VX3
500 HOURS
To Next Page
Loading...
