IHI 17VX3 - Parking the Machine

OPERATION
PARKING THE MACHINE
At the end of a day's work, following steps should be observed
as the established machine shut-down procedure:
Machine Stopping
Park on a level surface, if necessary to park on a grade, block
the tracks securely.
1. Move engine throttle lever forward to reduce the engine
speed.
2. Release the travel lever to stop the machine.
3. Lower the bucket to the ground and apply slight down
pressure.
4. Move the control shut-off lever to the LOCKED position.
Freezing Conditions
If freezing temperature are expected, each crawler frame should
be cleaned of mud and dirt and the machine parked on wood
planks.
Engine Stopping
1. Operate the engine at LOW IDLE for five minutes.
This gives the engine a chance to cool off gradually before
they are stopped.
2. Turn the start switch key to OFF. Remove the key.
Leaving the Machine
1. Use the steps and handhold, use both handles and face the
machine, when dismounting.
2. Inspect the entire machine for leaks, loose connections,
signs of wear, crack etc. Report any signs of trouble
discovered during this inspection.
3. Close and lock the doors.
EMERGENCY ENGINE STOP
To stop the engine in emergency, turn the start switch key to
"OFF" position.
3-15-1
17VX3
Wood
START SWITCH