OPERATION
BEFORE STARTING THE ENGINE
The following items should be checked each day before start-up or the start operations.
17VX3
•
Walk-Around
Inspection
Inspect the loose bolts, trash build
up,
oil or coolant leaks,
broken or worn parts. Inspect the condition of the
attachments and the hydraulic components.
Inspect the operator's compartment for cleanliness. Keep it
clean.
Inspect any cracks
in
boom and arm pivot area and cylinder
mounting brackets.
Repair if damaged.
Refer to Walk-Around Inspection
in
the Maintenance Section.
•
Lubrication
Perform the daily lubrication as required by the Lubrication
Chart.
• Pre-start
Checks
Check all of oil, coolant and fuel levels.
Refer to the Daily
in
the Maintenance Section for more
detailed information.
• Seat and Seat
Belt
Checks
Adjust the seat to allow full travel of the levers and pedals
when the operator
is
seated against the seat back.
Inspect the belt mounting hardware. Replace any damaged
or worn hardware. Keep the mounting bolt tight.
Fasten the seat belt before starting the engine.
3-2-1
To Next Page
Loading...
