IHI 17VX3 - Lower Roller Assembly

STRUCTURE
LOWER ROLLER ASSEMBLY
1. For Rubber Shoe:
Weight: 2.7 kg
17VX3
o 0
;::: ex:>
-e--9-
---------'"
Tightening torque
108 N-m
2. For Steel Shoe:
Shim (9 t)
(NOTE 6)
o 0
~ ex:>
-e--&
i
i
Tightening torque
--a.-.------+-f---+'~, ~.~....J, .@108N-m
--4t--H--I-I-t--f!:
~ I " • · . !P
____ .. _ .. j ~-i=U L. _
No. Description Q'ty Remarks
1 Guide Roller 1
2 Shaft 1
3 Gear Oil
~
25 cc
4 Plug 1
1/8
5 Bearing 2
6 Oil Seal 2
7 Snap Ring 2
NOTE:
1. Clean the roller, collar and shaft inside before
assembling to prevent mixture of foreign matter.
2. After assembling snap ring CV, place the roller
vertically and fill gear oil (SAE#90
e
API-GL4) of
25cc and install oil seal
®.
3. Perform the leak test after assembling. Apply
pressurized air of
98 kPa to the oil fill port @).
4. Wind a seal tape around plug @) and install it on
the roller.
5. Perform bolting with the crawler frame and lower
roller mounting face
in close contact with each
other.
6. In the case of steel shoe, insert a shim (9mm
thick) between the frame and shaft so as to allow
bolting with the mounting faces
in absolute contact.
2-17-1
Recommended oil Q'ty
API -GL4
25 cc
SAE#90