MAINTENANCE
10.
Fill the hydraulic tank with oil. See Recommended Lubricant
Table.
11.
Start and operate the engine at idling speed for five minutes.
12.
Operate the control levers to allow the hydraulic oil to
circulate through all hydraulic circuits.
13.
Lower the bucket to the ground with the arm and bucket
cylinder fully retracted and stop the engine.
14.
Maintain the oil level between FULL and ADD marks
on
the
level gauge.
15.
Pressurize the hydraulic tank.
Raise the boom with the arm, boom and bucket cylinder fully
extended. Remove the fill plug
CD
and then install fill plug
again.
16.
Lower the bucket
on
the ground and stop the engine.
-----[mCAUTIONIJ--------
Hydraulic Oil Change Intervals for Breaker Works.
Hydraulic oil should
be
changed
in
every 500 service hours.
4-9-3
17VX3
1000 HOURS
gauge
To Next Page
Loading...
