The Sequencing Analysis Viewer is included in the software installed on the instrument computer. You can
also install Sequencing Analysis Viewer on another computer linked to the same network as the instrument to
monitor run metrics remotely.
Automatic Post-Run Wash
When the sequencing run is complete, the software initiates an automatic post-run wash using the wash
solution provided in the buffer cartridge and NaOCl provided in the reagent cartridge.
The automatic post-run wash takes approximately 90 minutes. When the wash is complete, the Home button
becomes active. Sequencing results remain visible on the screen during the wash.
After the Wash
After the wash, the sippers remain in the down position to prevent air from entering the system. Leave the
cartridges in place until the next run.
Document # 15046563 v04
For Research Use Only. Not for use in diagnostic procedures.
23
NextSeq 500 System Guide
To Next Page
Loading...
