Page 100 Setup Manual
F.6 FCC Declaration of Conformity
Responsible party:
Image Access GmbH
Hatzfelderstrasse 161 – 163
42281 Wuppertal, Germany
Product: WideTEK 25-600
Model Designation: WT25 –XXX
(XXX represents the device version number and configuration details)
Serial number: All
This device complies with FCC 47, Part 15, Class A and ICES-003, Class A.
The test setup f ≤ 1000 MHz and test was done according to
ANSI C63.4: 2009 and CISPR 22: 2006+A1:2007
Compliance with CISPR 22 is being used to demonstrate conformity with FCC DoC
requirements. This conforms with FCC Part 15.107(e) and 15.109(g).
The test setup F> 1000 MHz and test was done according to
ANSI C63.4: 2009
American National Standard for Methods of Measurement of Radio-Noise Emissions from
Low-Voltage Electrical and Electronic Equipment in the Range of 9 kHz to 40 GHz.
NOTE: This equipment has been tested and found to comply with the limits for a
class A digital device, pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference
to radio communication. Operation of these equipment in a residential area is
likely to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
Wuppertal, 19.04.2012
Thomas Ingendoh , President and CEO
To Next Page
Loading...
Need help?
General
