Page 18 Setup Manual
B.1.1 Removing the Transport Box
Specially formed foam plastic inserts hold the scanner and the accessories in the
transport box.
At first, remove the plastic foam inserts and the cardboard boxes out of the transport box.
Start with the plastic foam elements at the corners of the scanner. Pull it out upwards.
Take the cardboard boxes out of the transport box at next.
Lift the wooden frame from the pallet.
Important! Because of safety reasons and because of the weight of the scanner,
execute the following step always with two persons.
Lift the scanner from pallet and place it on a flat and solid base.
The load bearing capacity of the base must correspond to the device weight. The
dimensions of the base must correspond to the length and depth of the scanner.
Note: Keep the wooden transport box and the foam plastic inserts for future use! In
case of guarantee the scanner must be sent back in the original transport box
to avoid transport damages.
To Next Page
Loading...
Need help?
General
