Setup Manual Page 83
D.6 Administrative Settings
D.6.1 Wake up Remote Host
If an external PC is used with the scanner, it can be helpful to start the PC at the same
time when the scanner starts.
This can be automatized by activating the Wake up Remote Host function.
Picture 67: Wake up Remote Host
The requirements for using this function:
In the BIOS of the external PC the function “Wake on LAN” must be activated.
It may be necessary to update the BIOS of older PCs for this function to be available.
The main power of the external PC must be active, but the PC can be in “Power save”
mode.
Enter the MAC address of the network card of the PC in the line “Hardware address”.
Select “Yes” at the line “Wake up remote host at PowerOn”.
To Next Page
Loading...
Need help?
General
