Page 44 Setup Manual
D.3.2 Network Configuration
The section Network Configuration is divided in nine subsections.
The Network Configuration start screen is the IPv4 (Network Interface 0) screen, which
is described in chapter D.3.2.2. The following description starts with the IP Configuration
Method screen.
D.3.2.1 IP Configuration Method
The function IP Configuration Method allows the operator to select between two
methods of IP configuration of the scanner.
Picture 23: IP Configuration Method
Allows setting the IP address, subnet mask, and default gateway manually;
corresponding to the network where the scanner will be used.
After modifying the above named values, the connection to the scanner
must be restored with the new data.
Sets the values for IP address, subnet mask, and default gateway
automatically, depending on the existing network where the scanner is
installed.
A DHCP server must be accessible in the network. For detailed information,
ask the network
administrator of the local network before selecting the
DHCP method.
When selecting DHCP the connection to the scanner is lost. The connection
to the scanner must be restored with the new data.
Important for the next steps:
After changing the network settings, enter the new IP address of the scanner in your
browser and reopen the Poweruser main menu as previously described.
To Next Page
Loading...
Need help?
General
