Page 30 Setup Manual
C.2 IP Address
Picture 12: Content of IP Address menu
To change or define the numeric values which make up an IP address, touch the number
in the respective line of IP address, gateway or netmask.
Touch the desired position in the respective row to move the cursor to that position.
To delete a digit, place the cursor right beside of the digit and press the “<=” button. It will
always be deleted from right to left.
Use the numeric keypad in order to enter digits.
Set network settings Saves the new or modified values when pressed.
Reset to Factory Sets all network parameters to factory default settings.
Reset network settings Sets all network parameters to previously defined value
when pressed. Chapter D.7.1 describes how to save the
parameters.
The section beside the numeric keypad shows device information.
To Next Page
Loading...
Need help?
General
